10/100/1000Mbps Gigabit Ethernet Switch GSD-503/GSD-504 GSD-803/GSD-804 User's Manual
Figure 2-5 & 2-6 show the front panel and rear panel of GSD-803 Figure 2-5 GSD-803 front panel Figure 2-6 GSD-803 rear panel Figure 2-7 & 2-8
receiving data over that port. 10 Green rating at 10Mbps. r Lit: indicate that the port is opeBlink: indicate that the switch is actively sending orec
Note: When choosing a location, please keep in mind the environmental restrictions discussed in Chapter 1, Section 1.4 Product Specification. Step4: C
3. SWITCH OPERATION 3.1 Address Table The Switch is implemented with an address table. This address table composed of many entries. Each entry is used
3.4 Store-and-Forward Store-and-Forward is one type of packet-forwarding techniques. A Store-and-Forward Ethernet Switching stores the incoming fra
connection is established with another network device (usually at Power On or Reset). This is done by detect the modes and speeds at the second of bot
4. TROUBLESHOOTING This chapter contains information to help you solve problems. If Giga Switch is not functioning properly, make sure the Ethernet Sw
This page intentionally left blank!
Appendix A A.1 Switch's RJ-45 Pin Assignments 1000Mbps, 1000Base T Contact MDI MDI-X 1 BI_DA+ BI_DB+ 2 BI_DA- BI_DB- 3 BI_DB+ BI_DA+ 4 BI_DC+ B
RJ-45 Connector pin assignment Contact MDI Media Dependant Interface MDI-X Media Dependant Interface - Cross 1 Tx + (transmit) RX + (receive) 2 Tx
Trademarks Copyright © PLANET Technology Corp. 2005. Content subjects to revision without prior notice. PLANET is a registered trademark of PLANET Tec
2010-A33110-000
FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. The
1. INTRODUCTION 1.1 Package Contents Check the contents of your package for following parts: 。 Gigabit Ethernet Switch x1 。 User's manual x1 。 Po
1.3 Product Features 。 Complies with IEEE802.3, 10Base-T, IEEE802.3u, 100Base-TX and IEEE802.3ab, 1000Base-T 。 IEE802.3x, full-duplex flow control com
1.4 Product Specifications Model GSD-503/GSD-504 GSD-803/GSD-804 Hardware Specification Network Ports 5 10/100/1000Base-T RJ-45 MDI/MDI-X ports 8 1
2. INSTALLATION This section describes the functionalities of the Gigabit Ethernet Switch’s components and guides how to install it on the desktop. Ba
This product also supports store-and-forward forwarding scheme to ensure low latency and high data integrity, eliminates unnecessary traffic and relie
Comments to this Manuals