- 1 - IEEE 802.3af Power over Ethernet Injector POE-151 User’s Manual
- 10 - APPENDIX A NETWORKING CONNECTION A.1 Switch‘s RJ-45 Pin Assignments RJ-45 Connector pin assignment Contact MDI Media Dependant In-terface
- 2 - Trademarks Copyright PLANET Technology Corp. 2006. Contents subject to revision without prior notice. PLANET is a registered trademark of
- 3 - TABLE OF CONTENTS 1. INTRODUCTION...
- 4 - 1. INTRODUCTION 1.1 Checklist Thank you for purchasing our POE-151 IEEE 802.3af Power over Ethernet Injector, your Power over Ethernet Inje
- 5 - 1.4 Specification Model POE-151 Ethernet Connector 2 x RJ-45( 1 for data + DC in, 1 for Data out) Ethernet Data rate 10/100Mbps( vary on
- 6 - 2. HARDWARE INSTALLATION This product provides two different running speeds – 10Mbps, 100Mbps in the same device and automatically d
- 7 - 2.2 POE-151, the Injector installation 1. Connect a standard network cable from Switch/workstation to “Ethernet” port of POE-151. 2. Conne
- 8 - Figure 3: Connection architecture over POE-151/151S Notice: 1. According to IEEE 802.3af standard, the POE-151 will not inject power to th
- 9 - 3.TROUBLESHOOTING This chapter contains information to help you solve problems. If the Switch is not functioning properly, make sure the Et
Comments to this Manuals